Greetings to all. Sorry this didn't happen sooner, but we should have all the pieces in place now to allow you to use the printers at Flex. Information was added this afternoon, and it usually takes an overnight refresh before everyone will have access to printers. The link below is from the Engineering Computer Network, and it describes how to map the various printers to your machines. You can contact the ECN staff who support Flex lab by sending an email to flexsite(a)ecn.purdue.edu<mailto:flexsite@ecn.purdue.edu>. Let me know if you run into any problems, and I'll try to work with ECN to assist.
-Dave
P.S Hope the install and training continues to go well
